System Description

UTM-00355 | Rev 2

Page 89 of 261

Advanced

The Advanced Mode option is more complex than the Basic Mode as it allows for multi-primed holes and the user will

need to control several parameters within this mode. To define a hole configuration the “Site Setup” screen will need

to be accessed. The Advanced (A) Tagging option also allows the user to tag detonators using Detonator Label

methods as follows:

 Method 1: {NNNNN} {N}, a hole number and det number is assigned.

 DigiShot Label

 Method 2: {NNN} {NNN} {N} a group number depicted as Row number, hole number and det number is

used.

 Method 3: {AA} {NNN} {N}, a user configurable 2 letter group number, hole number and det number is

assigned.

 Method 4: {A} {NNNNN} {N}, a user configurable single letter group number, hole number and det number is

assigned.

Tag by Plan

With the Planned (P) tagging option, both the location and a delay will be written into the detonator.

The data written into the detonator is taken from a plan downloaded into the CE4 Tagger via ViewShot.

When exporting the design from ViewShot as the connection sequence and blasthole numbers will be exported to the

tagger.

Manual locations can also be deployed separately from delays by using Advanced mode with “Assign Location” setting

checked. This feature can be used when the delays are not yet known.

Delays can be deployed to the tagged detonators later in Planned mode, using the available plan based on location

matching.