Workshop Manual

7.4 INSTALLATION OF THE COLD BOOST PIPE (CHARGE AIR PIPE)

Install the cold boost pipe as follows:

1. If the Intake Throttle Valve was removed r efer to section .

2. Install seal onto intake manifold.

3. Secure cold boost pipe to intake manifold with four bolts. Torque bolts to 30 N·m (22 lb·ft).

4. Attach support bracket to oil module with two bolts.

5. Install EGR mixer pipe.

6. If removed install seal, intake throttle valve and adaptor onto cold boost pipe. Torque four

bolts to 30-38 N·m (22-28 lb·ft).

7. Connect the sensor harness.

All information subject to change without notice.