Workshop Manual

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE

PERSONAL INJURY

To avoid injury when removing or installing a heavy engine

component, ensure the compo nent is properly supported

and securely attached to an adequate lifting device to

prevent the component from falling.

10. For EPA10 DD13 engines, connect the air line supply (1) to the EPV (2).

11. Connect the turbocharger speed sensor connector to the engine wiring harness.

12. Reconnect the ﬂange to the exhaust manifold.

13. Install the coolant inlet and outlet lines to the doser injector housing. Torque to 15 N·m

(11 lb·ft).

14. Install the fuel line to the doser injection valve. Torque to 23-25 N·m (17-18 lb·ft).

15. Install the turbocharger heat shields.

16. Install the two bolts to the turbocharger support bracket and turbocharger. Torque the

bolts to 25 N·m (18 lb·ft).

17. Install the compressor elbow and the Charge Air Compressor (CAC) plumbing. Torque

theclampsto6N·m(4lb·ft).

18. Connect the compressor inlet hose.

All information subject to change without notice.