Workshop Manual

9.5 EGR COOLER CLEANING PROCEDURE TO REMOVE EXCESS FUEL FROM COOLER AFTER DD13

TURBOCHARGER FAILURE

Check as follows:

NOTICE:

This cleaning procedure must be followed after replacing a DD13

turbocharger so that any failure will not cau s e excessive fuel, oil,

or coolant to enter the exhaust system. Failure to perform this

procedure could cause severe eng ine damage.

1. Shut off the engine, apply the parking brake, chock the wheels, and perform any other

applicable safety steps.

2. Remove the clamps (2) and the EGR hot pipe (3) from the EGR cooler and inspect for

any signs of liquid or moisture. The hot pipe and EGR cooler inlet should have a black

dry soot residue inside. Refer to section .

[a] If liquid or moisture is present in the pipe, go to the next step.

[b] If there is no sign of liquid or moisture in the pipe, install the EGR cooler hot pipe.

No further action is required. Refer to section .

All information subject to change without notice.