Workshop Manual

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE

14. Install the turbocharger oil drain line, using a new gasket and O-ring between the opening

in the bottom side of the turbocharger center housing and the drain line that runs to the

cylinder block. Torque the bolts to 30-38 N·m (22-28 lb·ft).

15. Install turbocharger oil supply line. Torque line to 30 N·m (22 lb·ft).

16. Install heat shields.

17. Install compressor elbow and charge air compressor plumbing. Torque clamps to 6 N·m

(4 lb·ft).

All information subject to change without notice.