Workshop Manual

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE

13.4 INSTALLATION OF THE AXIAL POWER TURBINE GEAR BOX

Install a s follows:

NOTICE:

Ensure the gear box gear and idler gear located in the gear case

housing are meshed. Failure to mesh gears correctly will cause

damage.

1. Install the gear box to cylinder block; ensuring the gears are meshed together when

installed.

NOTICE:

Ensure the correct bolt length is used when the gear box is

installed. If an incorrect bolt length (too long) is used, the cup

plugs installed in the cylinder block can be pushed out into the

gear train causing severe damage to the gear tra in. The correct

bolt le ngth for the bolt installed in the upper location near the

cylinder block is 35 mm (1.37 in). The c orrect length for the bolt

located in t he lower position of the gear box is 1 20 mm (4.72 in).

2. Install four bolts into gear box and cylinder block and hand tighten.

3. Torque the four bolts to 55-60 N·m (41-44 ft·lb).

4. Install oil line to gear box and engine block. Torque to 35 N·m (26 lb·ft).

All information subject to change without notice.