Workshop Manual

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE

18. Remove the EGR crossover tube. Refer to section .

19. Remove the two bolts attaching the cold boost pipe to the support bracket.

20. Using Flywheel and Main Pulley Socket tool (J-45390), remove the 40 bolts securing the

cylinder head to the cylinder block.

21. If the dipstick hose is a ttached to the intake throttle valve bracket, remove the clip

attaching it.

PERSONAL INJURY

To avoid injury when removing or installing a heavy engine

component, ensure the compo nent is properly supported

and securely attached to an adequate lifting device to

prevent the component from falling.

22. Using Cylinder Head/Engine Lifting Bar tool (W470589006200), remove the cylinder

head from the cylinder block.

23. Remove and discard the metallic gasket from the cylinder block.

All information subject to change without notice.