Workshop Manual

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE

14.5 CLEANING OF THE CYLINDER HEAD

Clean the cylinder head as follows:

1. Keep parts segregated according to original position to assure proper reassembly, if parts

are to be r eused.

2. Remove all plugs.

3. Steam clean the cylinder head once it has been stripped.

4. Clean the head in a de-scaling bath.

EYE INJURY

To avoid injury from ﬂying debris when using co mp ressed

air, wear adequate eye protection (face shield or safety

goggles) and do not exceed 276 kPa (40 psi) air pressure.

5. Clean the valves, springs, and rocker shafts in fuel oil and blow dry with compressed air.

6. Clean the rocker arm assemblies.

All information subject to change without notice.