Workshop Manual

14.14 INSTALLATION OF VALVE, SPRING, SEAL AND VALVE CAP

11. If the cylinder head is removed from engine, install cylinder head.

[a] For the DD13 ONLY: refer to section 14.3.

[b] For the DD15 ONLY: refer to section 14.7.

12. Prime fuel system. Refer to section .

13. Close any drain cocks that were opened and ﬁll the cooling system. Purge t he air from the

system using the vent in the thermostat housing. Complete ﬁlling of the cooling system

is essential for proper engine operation.

ENGINE EXHAUST

To avoid injury from inhaling engine exhaust, always

operate the engine in a well-ventilated area. Engine

exhaust is toxic.

14. Start the engine and check for leaks.

All information subject to change without notice.