Workshop Manual

14.15 VALVE LASH ADJUSTMENTS
9. Using a feeler gauge (1), lash exhaust valves one, three and five to 0.6 mm (0.024 in.).
10. Bar the engine over 360° until cylinder num ber six is at TDC compression stroke.
(J-46392)
11. Lash intake valves three, five, and six to 0.4 mm (0.016 in.).
12. Lash exhaust valves two, four and six to 0.6 mm (0.024 in.).
13. Torque the locknut valve adjusting screw to 50 N·m (37 lb·ft).
14. Remove any tools used for this procedure.
15. Set the engine brake lash. Refer to section 14.16.
All information subject to change without notice.
14-32 DDC-SVC-MAN-0081 201 0 Copyrig ht © 2010 DETROIT DIESEL CORPORATION