Workshop Manual

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE

15.3 DISASSEMBLY OF PISTON AND CONNECTING ROD ASSEMBLY

Piston assembly components should be segregated by cylinder and match-marked during

disassembly to ensure they are assembled in the same position and orientation.

NOTICE:

Stamping cylinder numbers on the piston assembly will damage

the compo nents.

Disassemble piston and connecting rod assembly as follows:

1. Place the piston, dome down, on the table.

2. Using appropriate ﬂat-nosed pliers, remove the retaining rings from the piston boss.

3. Slide out the piston wrist pin and remove the connecting rod from piston.

All information subject to change without notice.