Workshop Manual

16.2 REMOVAL OF CYLINDER LINER

Remove as follows:

NOTICE:

The proper method must be followed when removing the cylinde r

liner. Damage to the liners and cylinder block may occur if the

proper tools an d procedures are not used.

1. Remove the piston and connecting rod. Refer to section 15.2.

2. Install cylinder liner removal tool (J-45876) into the cylinder liner.

3. Remove cylinder l iner (2).

NOTICE:

After removing the liners from the engine and prior to installation,

always store them in an upright position until ready for use .

Liners left on their side for any length of time can become

egg-shaped and distorted, making installation in cylinder bores

difﬁcult or impossible. If the cylinder liners are to be reused, they

should be marked for cylinder location and engine orientation ,

a paint mark can be used to indicate the front of the engine so

they may be installed to the same cylinder from which t hey were

removed.

4. Remove the two seal rings (1, 3) from the cylinder liner (2) and discard them.

All information subject to change without notice.