Workshop Manual

16.3 INSPECTION OF CYLINDER LINER
4. Inspect the block bore and cylinder liner.
[a] Measure the block bore and the outside diameter of the liner.
Location DD13 DD15 DD16
A
158.98 to 159 mm
(6.2590to6.2598in.)
166.98 to 167 mm
(6.5740 to 6.5748 in.)
166.98 to 167 mm
(6.5740 to 6.5748 in.)
B
141.97 to 141.95 mm
(5.589 to 5.588 in.)
148.95 to 148.97 mm
(5.864 to 5.865 in.)
148.95 to 148.97 mm
(5.864 to 5.865 in.)
Table 16-1 Acceptable Cylinder Liner Diameters
[b] If the liner does not meet specification, replace with a new part.
5. Inspect the cylinder liner.
[a] Check the two seal ring grooves for burrs or sharp edges.
[b] If any are detected, smooth with a Scotch-Brite® pad.
All information subject to change without notice.
16-6 DDC-SVC-MAN-0081 201 0 Copyrig ht © 2010 DETROIT DIESEL CORPORATION