Workshop Manual

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE

16.4 CLEANING OF THE CYLINDER LINER

Clean as follows:

NOTE:

If using de-greasing solution to clean cylin der liner when ﬁnishe d, an application of clea n

engine oil will need to be app lied to protect the cylinder liner from corrosion.

1. If cleaning a new or used liner, use a clean cloth and clean engine oil.

To avoid injury from ﬂying debris when using co mp ressed

air, wear adequate eye protection (face shield or safety

goggles) and do not exceed 40 psi (276 kPa) air pressure.

2. Dry the liner with compressed air.

NOTICE:

If the liners a re not to be installed at this time, oil them lightly with

clean engine lubricating oil an d store them upright in a c lean, dry

area. Do not let the lin ers rest on their sides and do not store

anything on top of the liners.

3. Coat the bore of the liner with clean engine lubricating oil.

4. Allow the liner to sit for 10 minutes (to allow the oil to work into the surface ﬁnish).

5. Wipe the inside of the liner with white paper towels.

6. If a dark residue appears on the towels, repeat the oiling and wiping procedure until

residue no longer a ppears.

All information subject to change without notice.