Workshop Manual

16.5 INSTALLATION OF THE CYLINDER LINER

Install as follows:

1. Wipe the inside and outside of the liner clean.

NOTE:

Thoroughly clean the cylinder block, liner, and coun ter bores to remove any foreign

material. Foreign material in the cylind er liner counter bores can cause the liner to

seat improperly. Clean with a w ire brush.

2. Install the two new seal rings (1, 3) onto t he cylinder liner (2).

NOTE:

Ensure when installed, the seal rings are properly seated in the proper grooves (locations

1 and 3).

3. Lubricate the seal rings with clean engine oil.

4. Install the cylinder liner in cylinder block bore using cylinder liner installation tool

J-45876.

All information subject to change without notice.