Workshop Manual

17.2 REM O VAL OF CRANK SHA F T

17.2 REMOVAL OF CRANKSHAFT

When removal of the crankshaft becomes necessary, ﬁrst remove the transmission, then proceed

as follows:

1. Steam clean the engine.

2. Drain the cooling system. Refer to OEM procedures.

3. Drain the lubricating oil. Refer to OEM procedures.

PERSONAL INJURY

To avoid injury whe n removing or installing a heavy engine

component, ensure the component is properly supported

and securely attached to an adequate lifting device to

prevent the component from fa lling.

4. Attach Cylinder Head/Engine Lifting Bar tool (W470589006200) with hooks to the three

engine lifter brackets (one at the front and two at the rear). Remove all engine-to-base

attaching bolts and remove the engine from its chassis.

FALLING ENGINE

To avoid injury from a falling engine, ensure the engine

is securely attached to the engine overhaul sta nd before

releasing the lifting sling.

All information subject to change without notice.