Workshop Manual

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE

5. Remove and inspect all of the accessories and assemblies with their attaching parts, as

necessary, to permit the engine block adaptor to be bolted to the intake (left) side of

the cylinder block. Mount the engine to the overhaul s tand (J–29109) with adaptor

(J–35635–A).

6. Remove the oil pan. Refer to section 19.2.

7. Remove the oil pump. Refer to section 21.2.

8. Remove the ﬂywheel. Refer to section 34.4.

9. Remove ﬂywheel housing. Refer to section 34.2.

NOTICE:

Use care when removing the crankshaft pulley a nd vibration

assembly. If the damper is allowed to fall, damage to the internal

components of the damper may result.

10. Loosen and remove two of the crankshaft pulley retaining bolts and hardened w ashers 180

degrees apart and install Flywheel Guide Studs tool (J–36235) in their p lace. Then loosen

and remove the remaining six pulley retaining bolts and hardened washers.

11. Remove the vibration damper assembly. Refer to section 36.1.

12. Remove front cover. Refer to section 37.2.

13. Remove connecting rod caps, and/or piston assemblies (if necessary). Refer to section

15.2.

14. Rotate the engine so the crankshaft is facing up.

All information subject to change without notice.