Workshop Manual

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE

17.6 INSTALLATION OF THE REAR OIL SEAL

Install a s follows:

NOTE:

The standard size rear oil seal has an inside diame ter of 138 mm (5.433 in.).

1. Inspect the contact area of the ﬂywheel for damage and wear. If it is scored or worn,

replace it.

2. Install the new rear seal (2) onto the Rear Crankshaft Seal Installer & Remover tool

(W470589004300).

NOTE:

For ease of installation into the ﬂywhe el housing, apply a light coating of a soapy w ater

solution to the outer diameter (2) of the sea l.

3. Position the seal into the ﬂywheel housing (1).

All information subject to change without notice.