Workshop Manual

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE

3. Install seal (1) and plastic installation tool (2) into the front cover ( 3) and crankshaft;

remove plastic seal installation tool (2) and discard.

4. Install Front Crankshaft Seal Installer/Remover tool (W541589023300) to the crankshaft.

5. Install the seal by turning the forcing screw until the tool bottoms out on the end of the

crankshaft.

6. Remove the tool and visually check the seal and sealing lip for correct installation. The

seal lip should face outward when installed correctly.

All information subject to change without notice.