Workshop Manual

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE

2.2 REMOVAL OF CAMSHAFT AND ROCKER SHAFT/ENGINE BRAKE

ASSEMBLY

Remove as follows:

1. Turn engine OFF, (key OFF, engine OFF).

2. Steam clean the engine.

3. Disconnect the battery power to the engine. Refer to OEM procedure

4. Remove the air cleaner and the turbocharger inlet pipe and hose. Refer to OEM procedures.

5. Remove air cleaner housing. Refer to OEM procedures.

6. Remove the rocker cover. Refer to section 1.2.

7. Remove the two 14-pin fuel injector harness connectors (1) from the camshaft housing

housing (2).

NOTE:

Top Dead Center (TDC) can be conﬁrmed by installing camshaft timing too l. For

the DD13 use Camshaft Timing Tool (W4705 89034 000). For the EPA07 DD15 use

Camshaft Timing Tool

(W470589054000). For th e EPA10 DD15 use Camshaft Timing

Tool (W470589104000).

8. Using Engine Barring tool (J-46392), rotate the crankshaft to TDC on cylinder No. 1.

All information subject to change without notice.