Workshop Manual

19.7 INSTALLATION OF OIL PAN

7. Ensure that the seal has not been disturbed. Torque the eighteen oil pan bolt assemblies to

20 N·m (15 lb·ft) using the proper sequence.

8. Install the oil pan drain plug and torque the plug to 45 N·m (33 lb·ft).

9. Install bolt at harness P-clamp on front center of oil pan.

10. Install dipstick tube ﬁtting if removed from pan and torque to speciﬁcation listed in Table

19-1.

Fitting Thread Size Torque Spec

Fitting to pan M20x1.5 60 N·m (44 lb·ft)

Fitting to pan M22x1.5 70 N·m (51 lb·ft)

Fitting to pan M27x1.5 90 N·m (66 lb·ft)

Fitting to pan M30x1.5 100 N·m (73 lb·ft)

Table 19-1 Torque S pecs for Pan Fittings

11. Install dipstick tube on ﬁtting and tighten clamp. Refer to section 20.3.

12. Install dipstick.

13. Install oil ﬁlter and cap. Torque to 55 N·m (40 lb·ft).

14. If oil pump was removed, follow section 21.4.

15. Prime the lubrication system. Refer to section 27.1.

16. Reﬁll the oil pan with lubricating oil. (refer to specs for oil quantities).

All information subject to change without notice.