Workshop Manual

21.4 INSTALLATION OF THE OIL PU MP, OIL SUCTION MANIFO LD, AND OIL LINE S

21.4 INSTALLATION OF THE OIL PUMP, OIL SUCTION MANIFOLD, AND

OIL LINES

Install as follows:

1. Check the oil pump part number to be sure it is correct for this application.

2. Position the oil pump on the cylinder block so that the drive gear of the oil pump meshes

with the crankshaft gear.

3. Install oil pump w ith three bolts. Torque the bolts to 30 N·m (22 lb·ft).

4. Install oil lines with new O-rings on each end.

5. Install four bolts and secure the oil intake manifold to the cylinder block. Torque the

bolts to 60 N·m (44 lb·ft).

6. Install t he oil pan. Refer to section 19.7.

All information subject to change without notice.