Workshop Manual

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE

22.2 REMOVALOFTHECRANKCASE BREATHER

Remove as follows:

1. Disconnect speed sensor electrical harness connection, on EPA10 engines, from the

crankcase breather and unclip the electrical harness from the crankcase breather assembly.

NOTE:

Note orientation of bracket located on top bolt.

2. On EPA07 engines, remove the two bolts and gasket from the breather pipe. Discard

gasket.

3. On EPA10 engines, disconnect the quick-connect ﬁtting at the cylinder block.

4. Remove the four bolts and gasket from the crankcase breather and remove crankcase

breather from the cylinder block. Discard the gasket.

All information subject to change without notice.