Workshop Manual

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE

26.3 INSTALLATION OF THE OIL COOLANT M ODULE

Install a s follows:

1. Install thermostat to oil coolant module with four bolts. Torque to 20-25 N·m (15-19 lb·ft).

2. Install E xhaust Manifold Guide Studs tool (J–36107) into the cylinder block to assist in

guiding the oil coolant module onto the cylinder block.

3. Install new gasket.

4. Install the oil coolant module onto the guide studs and cylinder block.

5. Install eleven bolts and torque to the following:

□ 10 N·m ( 7 lb·ft)

□ Final torque the bolts to 60-65 N·m (44-47 lb·ft)

6. Remove tool (J–36107). Install the remaining two bolts into the oil cooler module. Torque

the bolts to the following:

□ 10 N·m ( 7 lb·ft)

□ Final torque the bolts to 60-65 N·m (44-47 lb·ft)

7. Install the dipstick tube and two bolts and torque to 15 N·m (11 lb·ft).

8. Install t he radiator support strut bracket. Torque to 100 N·m (74 lb·ft).

9. Install water pump if removed. Refer to section 29.4.

10. Install poly-V-belt to water pump pulley. Refer to section 40.3.

11. Install electrical engine harness to the sensor.

12. Connect coolant line to fuel module and oil coolant module.

13. Install heater hose to oil coolant module.

All information subject to change without notice.