Workshop Manual

27.1 PRIMING THE ENGINE LUBRICATION SYSTEM

3. Install Oil System Priming Adaptor tool (J–49181) into the oil priming port (1) in the

oil coolant module.

4. Install Engine Preluber Kit (J–45299) to the ﬁtting adaptor (1).

5. Fill the canister with eight quarts of oil.

6. Open the valve on the primer and start pumping until the container is empty.

7. Fill the container with an additional eight quarts of oil and pump until the canister is empty.

8. The oil system is now primed with sixteen quarts of oil. Pour the remaining oil into the oil

ﬁller until the correct full level is obtained.

All information subject to change without notice.