Workshop Manual

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE

9. Close the valve and loosen the ﬁtting; do not completely remove it from the adaptor.

10. Remove the priming adaptor (1) from the oil coolant module (2) with the line attached to

keep the oil from ﬂowing out of the module.

11. Install the allen head plug or oil sample valve to the module and torque to 70-80 N·m

(51-59 lb·ft).

ENGINE EXHAUST

To avoid injury from inhaling engine exh aust, always

operate the engine in a well-ventilated area. Engine

exhaust is toxic.

12. Start the engine and monitor the oil pressure.

13. After the engine oil pressure stabilizes, shut the engine down and check the oil per the

oil check guidelines.

All information subject to change without notice.