Workshop Manual

29.4 INSTALLATION OF THE WATER PUMP

Install as follows:

1. Install the water pump seal (5) to the water pump (4).

2. Install the water pump (4) to the oil coolant module (6) with nine bolts (3) and torque to

30 N·m (22 lb·ft).

3. Install the water pump pulley (2) to the water pump with ﬁ ve bolts (1) and ﬁnger tighten

and install belt.

4. Install the poly-V-belt. Refer to section 40.3.

5. Torque the water pump pulley bolts to 25 N·m (18 lb·ft).

6. Fill the coolant system.

7. Reconnect the batteries.

ENGINE EXHAUST

To avoid injury from inhaling engine exhaust, always

operate the engine in a well-ventilated area. Engine

exhaust is toxic.

8. Start the engine and inspect for leaks.

All information subject to change without notice.