Workshop Manual

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE

30.2 REMOVAL OF COOLANT THERMOSTAT AND SEAL

Remove as follows:

HOT COOLANT

To avoid scalding from the expulsion of h ot coolant, never

remove the cooling system pressure cap while the engine

is at operating temperature. Wear ad equate protective

clothing (face shield, rubber gloves, apron, an d boots).

Remove the cap slowly to relieve pressure.

1. Drain the cooling system.

2. Remove the plug on the cylinder block below the oil coolant module to drain the

remaining coolant.

3. Loosen hose clamp at the thermostat.

4. Remove the four thermostat housing-to-oil cooler module attaching bolts.

5. Remove the thermostat housing assembly from the oil coolant module and hose.

6. Remove the thermostat housing seal.

All information subject to change without notice.