Workshop Manual

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE

30.4 INSTALLATION OF COOLANT THERMOSTAT AND SEAL

Install a s follows:

1. Install seal (2) onto thermostat housing (3).

2. Install thermostat into hose and onto oil cooler module (1).

3. Torque four bolts to 30 N·m (22 lb·ft).

4. Tighten clamp at the hose.

5. Fill engine with coolant to the correct level.

ENGINE EXHAUST

To avoid injury from inhaling engine exh aust, always

operate the engine in a well-ventilated area. Engine

exhaust is toxic.

6. Start the engine and check for leaks.

All information subject to change without notice.