Workshop Manual

2.4 INSTALLATION OF THE CAMSHAFT AND ROCKER SHAFT/ENGINE BRAKE ASSEMBLY

2.4 INSTALLATION OF THE CAMSHAFT AND ROCKER SHAFT/ENGINE

BRAKE ASSEMBLY

Install as follows:

1. Verify that the crankshaft is at top dead center (TDC) on cylinder number one using

TDC Locating Pin (W470589001500) installed in crankshaft position sensor (CKP) hole

located in the ﬂywheel housing.

2. Install Camshaft Timing Tool (W470589054000) (1) for EPA07 DD15, (W470589104000)

for EPA10 DD15, and (W470589034000) for EPA10 DD13 to the rear of the camshaft

housing. Tighten the two bo

lts.

All information subject to change without notice.