Workshop Manual

34.2 REMOVAL OF FLYWHEEL HOUSING

34.2 REMOVALOFFLYWHEELHOUSING

Remove as follows:

1. If the engine is removed from the vehicle, mount the engine on an overhaul stand.

2. Drain engine oil and remove the oil pan.

3. Remove the doser injector feed line.

4. Remove the Crankshaft Position Sensor (CKP). Refer to section .

5. Remove the ﬂywheel. Refer to section 34.4.

6. Remove two bolts securing exhaust pipe bracket to ﬂywheel housing.

7. For the DD15; remove the clamp from the exhaust pipe and the axial power turbine

and then remove exhaust pipe.

8. Thread eye bolts into the tapped holes in the side of the ﬂywheel housing and attach a

suitable lifting sling to the eye bolts.

9. Thread two guide stud tools (J-43431) for the 14 mm bolts, into the cylinder block.

10. Remove the remainder of the bolts that secure the ﬂywheel housing to the cylinder block.

BODILY INJURY

To avoid inju ry from a falling component, ensure a proper

lifting de vice is used. Never stand beneath a suspended

load.

11. Strike the front face of the housing a lternately on each side with a soft hammer to loosen

and work it off the dowel pins.

12. Remove and discard the ﬂywheel housing gasket.

13. Remove all sealing material from the ﬂywheel housing.

All information subject to change without notice.