Workshop Manual

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE

34.3 INSTALLATION OF FLYWHEEL HOUSING

Install a s follows:

1. Thread two guide studs (J–43431) for 14 mm bolts, into the cylinder block to guide the

housing in place.

2. Install a new gasket.

BODILY INJURY

To avoid injury from a falling component, ensure a proper

lifting device is used. Never stand be neath a suspe nded

load.

3. Using a lifting sling support t he ﬂywheel housing and position it onto the cylinder block.

4. Install all of the housing bolts in their proper location; ﬁnger-tighten them.

All information subject to change without notice.