Workshop Manual

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE

34.4 REMOVAL OF THE FLYWHEEL

Pre-cleaning is not necessary.

Remove as follows:

1. Remove the crankshaft position sensor (CKP). Refer to section .

2. Remove eleven of the twelve ﬂywheel attaching bolts, leaving one bolt at the 12 o'clock

position.

3. Install two ﬂywheel guide studs (J–41672) through the ﬂywheel and into the crankshaft

at the 3 and 9 o'clock positions.

4. Attach the ﬂywheel lifting tool (J–25026) or some other suitable lifting device, to the

ﬂywheel.

5. Attach a chain hoist to the l ifting tool.

6. Loosen, but do not remove the last ﬂywheel attaching bolt.

FALLING FLYWHEEL

To avoid i njury from a falling ﬂywheel when re moving the

last bolt, hold the ﬂywheel again st the crankshaft by hand

to prevent it from slipping off the cran kshaft. The ﬂywheel

is not doweled to the crankshaft.

7. Lift lightly on ﬂywheel using lifting device and remove last bolt.

BODILY INJURY

To avoid injury from a falling component, ensure a proper

lifting device is used. Never stand be neath a suspe nded

load.

8. Remove ﬂywheel.

All information subject to change without notice.