Workshop Manual

2.4 INSTALLATION OF THE CAMSHAFT AND ROCKER SHAFT/ENGINE BRAKE ASSEMBLY

[b] If there is excessive drag when installing the tool, the camshafts are out of time. If so,

repeat this procedure at Step 3.

7. Verify that the marks on the gear teeth match the marks on the timing tool.

NOTICE

The camshaft caps are numbered and ne ed to be installed

correctly.

8. Install the seven camshaft caps onto intake and exhaust camshafts.

9. The ﬁrst and seventh camshaft caps hold the engine brake solenoid to camshaft cap.

Replace the O-rings o

n the solenoid prior to reinstallation. Install the engine brake

solenoid.

NOTE:

There are 30 bolts r

etaining the DD13 camsh aft assemblies (shown ); 14 120 mm (M10)

bolts, seven 108 mm (M10) bolts and n ine 63 mm (M8) bolts. The DD15 uses 28 bolts,

with two external bolts at the rear of the camshaft housing.

All information subject to change without notice.