Workshop Manual

34.5 INSPECTION OF FLYWHEEL

Inspect as follows:

1. Inspect the clutch contact base of the ﬂywheel.

[a] Check clutch contact base for scoring, wear, or cracks.

[b] The ﬂywheel may be re-faced if the clutch contact face is scored or worn.

[c] The ﬂywheel must be replaced if the clutch contact face shows cracks.

2. Inspect the ring gear.

[a] Check ring gear for excessively worn or damaged gear teeth.

[b] If damaged gear teeth are detected, replace the ring gear.

3. Inspect crankshaft and ﬂ ywheel contact surface.

[a] Check the butt end of the crankshaft and ﬂywheel contact surface for damage.

[b] Lightly stone the contact surface to remove any fretting, brinelling, or burrs.

All information subject to change without notice.