Workshop Manual

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE

34.6 INSTALLATION OF FLYWHEEL

Install a s follows:

1. Install two ﬂywheel guide studs (J–36235) into two of the tapped holes in the crankshaft

at the 3 and 9 o'clock position.

NOTICE:

Maximum ﬂywheel bolt length for reuse is 88mm, if bolt length

exceeds this, replace the u s ed bolts with new bolts.

2. Properly attach the ﬂ ywheel lifting tool to the ﬂywheel and, using a chain hoist, position

the ﬂywheel in the ﬂywheel housing.

□ Align the ﬂ ywheel bolt holes with the crankshaft bolt holes.

□ Be sure to line up the locating pin hole with the pin on the crankshaft.

3. Remove the ﬂywheel lifting tool and guide studs.

4. Apply clean engine oil to the threads and to the bolt head contact area (underside) of the

remaining bolts. Any excess must be wiped off.

NOTE:

Clean e ngine oil must never be used between two surfaces where maximum friction is

desired, as between the crankshaft and the ﬂywheel.

5. Install the ﬂywheel lock J-46392 or W470589046300.

6. Install the bolts and torque them to 200-220 N·m (147-162 lb·ft) and then an additional

90° to 100° torque turn.

All information subject to change without notice.