Workshop Manual

2.4 INSTALLATION OF THE CAMSHAFT AND ROCKER SHAFT/ENGINE BRAKE ASSEMBLY

12. Using the torque sequence shown below, torque the nine 63 mm M8 bolts to 30 N·m

(22 lb·ft).

13. Remove TDC Locating Pin (W470589001500) from CKP sensor hole in the ﬂywheel

housing.

14. Install crankshaft position se

nsor. Refer to section .

15. Install a dial indicator onto gear case and zero out the dial indicator.

16. Position the stem of dial indicator to rest between the teeth on the camshaft gear.

17. Hold the number ﬁve idler

gear with a screwdriver. Check the lash between the camshaft

gear and idler gear number ﬁve.

All information subject to change without notice.