Workshop Manual

37.4 INSTALLATION OF THE FRONT ENGINE COVER

Install as follows:

1. Install a new front cover housing gasket on the cylinder block.

2. Install the front cover housing to the cylinder block. Torque the front cover m ounting bolts

to 60 N·m (44 lb·ft) in the sequence shown.

3. Install the oil pan to cylinder block. Refer to section 19.7.

4. Install the splash ring on the front of the crankshaft.

5. If the front crankshaft seal is damaged and requires replacement, replace as necessary.

Refer to section 17.8.

6. Install the vibration damper and pulley to the crankshaft. Refer to section 36.2.

7. Install the poly-V-belt. Refer to section 40.3.

All information subject to change without notice.