Workshop Manual

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE

38.3 REMOVALOFTHEFRONTENGINE LIFTER BRACKET WITH FRONT

ENGINE POWER TA KE- OFF

For EPA 07 engines, remove as follows:

1. Loosen the two hose clamps on the venturi to mixer pipe hose.

2. Slide the connector hose fully on the mixer pipe. If hose is cut, torn, or cracked, then

remove and discard it.

3. Remove the two bolts attaching the venturi to the exhaust gas crossover tube/lifting eye.

4. Remove the six bolts attaching the exhaust gas crossover tube/lifting eye to the cylinder

head.

5. Remove the bolt attaching the exhaust gas crossover tube/lifting eye to the coolant

crossover t ube.

6. Remove the bolt attaching the coolant crossover tube to the exhaust gas crossover

tube/lifting eye.

7. Slide the exhaust gas crossover t ube/lifting eye off the exhaust gas connector tube and

remove from engine.

8. Remove the exhaust gas connector tube from the EGR cooler.

□ Inspect the exhaust gas connector tube for cuts, tears, or cracks or other signs of

damage.

□ If damage is found, replace connector tube.

All information subject to change without notice.