Workshop Manual

38.8 INSTALLATION OF THE FRONT ENGINE LIFTER BRACKET WITH FRONT ENGINE POWER

TAKE-OFF

38.8 INSTALLATION OF THE FRONT ENGINE LIFTER BRACKET W ITH

FRONT ENGINE POWER TAKE-OFF

For EPA07 engines, install as follows:

1. Install a new EGR connector tube, if needed, onto EGR cooler and install EGR exhaust

gas crossover tube/lifting eye to cylinder head.

2. Loosely install six bolts to exhaust gas crossover tube/lifting eye.

3. Install bolt attaching the exhaust gas crossover tube/lifting eye to the coolant crossover

tube. Torque to 30 N·m (22 lb·ft).

4. Install bolt attaching the coolant crossover tube to the exhaust gas crossover tube/lifting

eye. Torque to 30 N·m (22 lb·ft).

5. Tighten six exhaust gas crossover tube/lifting eye bolts to cylinder head. Torque to 60

N·m (44 lb·ft).

6. Slide mixer pipe onto hose with soap and water for ease of installation.

7. Install venturi to exhaust gas crossover tube/lifting eye with a new gasket and two bolts;

torque bolts to 30 N·m (22 lb·ft).

8. Slide hose onto venturi using soap and water for ease of installation.

9. Install two clamps onto hose and tighten.

All information subject to change without notice.