Workshop Manual

40.1 RE MOVAL OF THE POLY-V-BELTS

2. Turn the grooved pulley i dler arm counterclockwise. Maximum allowable torque is

90-100 N·m (66-73 lb·ft).

3. Insert an M10x80 bolt (or equivalent pin), into the bracket hole (2) in the idler arm.

4. Release the idler arm. The grooved pulley idler arm is now locked in a pre-tensioned

position.

5. Remove the belt.

6. Install a half-inch extension into the square hole (V) on the non-grooved pulley idler

arm (1).

7. Turn the non-grooved pulley idler arm counterclockwise. Maximum allowable torque is

90-100 N·m (66-73 lb·ft).

All information subject to change without notice.