Workshop Manual

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE

25. With the engine mounted on the overhaul stand, remove all of any remaining

subassemblies and parts from the cylinder block.

[a] Remove the rocker cover. Refer to section 1.2.

[b] Remove the engine lifter brackets. Refer to section 38.2.

[c] Remove the vibration damper. Refer to section 36.1.

[d] Remove the ﬂywheel. Refer to section 34.4.

[e] Remove ﬂywheel housing. Refer to section 34.2.

[f] Remove idler gears. Refer to section 5.2.

[g] Remove camshaft housing. Refer t o section 3.1.

[h] Remove the cylinder head. For DD13, refer to section 14.2. For DD15,

refer to section 14.4.

[i] Remove the oil pan. Refer to section 19.2.

[j] Remove the piston and connecting rod assembly. Refer to section 15.2.

[k] Remove cylinder liners. Refer to section 16.2.

[l] Remove the crankshaft. Refer to section 17.2.

NOTICE:

Before removing main bearing caps, be sure each is stamped

or punch-marked in numerical order, beginning with No. 1 at

the front, to ensure installation in their original position. Mark

all caps on the oil cooler side (left side) of the en gine to preve nt

reversal at assembly. Failure to mark numerical order may result

in the caps being put back in incorrect order, improper crankshaft

support and severe crankshaft or bearing damage o r both.

[m] Remove the crankshaft main bearings.

All information subject to change without notice.