Workshop Manual

EPA07/10 DD PLATFORM WORKSHOP MANUAL - ENGINE

3.3 INSTALLATION OF THE CAMSHAFT HOUSING

Install a s follows:

1. Install a new seal into the camshaft housing.

2. Using an appropriate lifting device install camshaft housing onto the cylinder head.

PERSONAL INJURY

To avoid injury when removing or installing a heavy engine

component, ensure the component is properly supported

and securely attached to an adequate lifting device to

prevent the component from falling.

3. Ensuring that no oil gets into the bearing cap

dowel pin hole, lubricate the camshaft

housing camshaft journals.

4. Install the camshaft assemblies into the camshaft housing. Refer to section 2.4.

5. Install the following high pressure fuel

line components:

[a] High pressure fuel line bracket (1), and high pressure fuel lines from fuel rail to high

pressure fuel pump (2); refer to section .

[b] High pressure fuel lines from fue

l rail to fuel injectors (3); refer to section .

[c] Fuel line from fuel rail to fuel ﬁlter module (4); refer to section .

6. Install the rocker cover. Refer to section 1.4.

7. Prime th

e fuel system. Refer to section .

All information subject to change without notice.