Workshop Manual

5.2 ENGINE GEAR TRAIN INSTALLATION AND TIMING

Install and time the gear train as follows:

NOTE:

Coat the inside of the ge ars, bushings and g ear train with clean oil before installation.

1. Install the crankshaft gear on the crankshaft.

2. Rotate the crankshaft to top dead center (TDC) on cylinder number one. Install and lock

Crankshaft TDC Locating Tool (J-48630) into place with bolt.

3. Install spindle into idler ge

ar number ﬁve.

4. Install idler gear number ﬁ ve onto the cylinder head using Shoulder Bolt (J-47486).

5. Install two bolts into idler gear number ﬁ ve and hand tighten. Remove (J-47486). Torque

to 60-65 N·m (44-48 lb·f

t).

6. Install the spindle into idler gear number three.

All information subject to change without notice.