Workshop Manual

6.4 INSTALLATION OF THE DD15 & DD16 WATER MANIFOLD

Install as follows:

NOTICE:

Ensure when installing the connecting pipe, that the pipe is

lubricated with clean oil. see Figure 6-1 If it is not lubricated, the

connecting pipe can not be fully installed and the rubber can be

cut.

NOTICE:

Do not use sealant wh en installing water manifold to the cylinder

head.

1. Install water manifold gaskets and connecting pipe onto the water manifold.

2. Install six lower water manifold bolts and start by a few threads.

3. Install w ater manifold onto cylinder head.

4. Install eleven upper water manifold bolts.

5. Torque the water manifolds bolts to 30 N·m (22 lb·ft), using the torque sequence illustrated

below.

6. Ins

tall EGR cooler to water manifold and torque to 20 N·m (15 lb·ft).

All information subject to change without notice.