Owner manual

PT Series • Heater Contents • Lighting • Shutdown • Parts
Note: Reference the manual for installation requirements.
Heater Contents
Natural Gas
1 Open gas supply.
2 Check all gas connections for leaks using a soap and water solution. (DO NOT USE AN OPEN FLAME).
3 Light and place a match on ceramic burner through the hole provided on the side of the reector (#4 above).
DO NOT LIGHT HEATER AT THE ORIFICE OR ATTEMPT TO LIGHT WITH A SPARK LIGHTER.
4 Depress the BRASS button on the heater’s safety valve. Heater should light within ten seconds.
5 Continue to depress the brass for approximately one minute and then release.
6 If heater ame extinguishes, wait ve minutes before repeating above steps.
Lighting
1
6
1 P16 or P32 Heater Core
2 Reector
3 Mounting Hole
4 Lighting Hole
5 Gas Valve with Orice Spud
6 Natural Gas Regulator
7 3/8” - 16 Thumbscrew
*
Hose & LP regulator assembly and angle mounting
bracket are not included.
Portable Heater Parts (for Natural Gas)
Other
Part No. Description
1
P-109N P-16T Natural gas orice spud
1
P-110 N P-32T Natural gas orice spud
2
P-122 Natural gas regulator - set 6.0” W.C.P.
3
P-127 P-32N Natural gas valve (assembled with all ttings)
3
P-128 P-16N Natural gas valve (assembled with all ttings)
Refer to Portable Heater (LIOPT) Installation, Operation, Maintanance and Parts Manual for full instructions and
safety information.
1
Portable Heater Parts (Natural Gas)
3
2
Shutdown
1
Close gas supply.
4
3
2
5*
7