Operating instructions

- 23 -
SYMPTOM CAUSE CORRECTIONS
Oven lamp and fan motor turn
on
1. Misadjustment or loose wiring
of primary latch switch
2. Defective primary latch switch
Adjust door and latch switches.
Oven can program but timer
does not start.
1. Open or loose wiring of secondary i
nterlock switch
2. Off-alignment of primary interlock
3. Defective secondary interlock S/W
Adjust door and interlock switches.
Microwave output is low;.
Oven takes longer time to
cook food.
1. Decrease in power source voltage.
2. Open or loose wiring of magnetron
filament circuit. (Intermittent oscillation))
3. Aging of magnetron
Consult electrician.
Fan motor turns on when
plugged in
Loose wiring of door sensing switch Check wire of door sensing switch.
Oven does not operate and
return to the plugged in mode.
Defective Ass’y PCB
Replace PCB main.
Loud buzzing noise can be
heard.
1. Loose fan and fan motor
2. Loose screws on H.V.Transformer
3. Shorted H.V.Diode
Tighten screws of fan motor.
Tighten screws of H.V.Transformer.
Replace H.V.Diode.
Turntable motor does not
rotate.
1. Open or loose wiring of turntable motor.
2. Defective turntable motor.
Replace turntable motor.
Oven stops operation during
cooking
1. Open or loose wiring of primary interlock
switch
2. Operation of thermal cutout (Magnetron)
Adjust door and latch switches.
Sparks 1. Metallic ware or cooking dishes touching
on the oven wall.
2. Ceramic ware trimmed with gold or
silver powder also causes sparks.
Inform the customer.
Do not use any type of cookware
with metallic trimming.
Uneven cooking Uneven intensity of microwave due to its
characteristics.
Wrap thinner parts of the food with
aluminum foil.
Use plastic wrap or cover with a
lid. Stir once or twice while cooking
foods such as soup, cocoa, or milk.
Noise from the turntable motor
when it starts to operate.
Noise may result from the motor. Replace turntable motor.
Display error1 Shorted sensor’s circuit. Let oven cool for at least 5minutes.
Check connection of the sensor if
the sensor’s circuit was shorted or
not by the alien substance.
Display error2 Open sensor’s circuit. Check connection of sensor’s wire.
Display error3 On the cooling mode, sensor’s Vout was
not less than 4.7V within 3minutes.
Let oven cool for at least 5minutes.
Display error4 On the way to sensing, the door was open. Press the ‘pause/cancel’pad, and
then you have to do all over again.
6-1 Electrical Malfunction(continued)