Specifications

Service Training
Page 4.2
Section 72
09.04
noyes
Δp von 10 - 11 bar.
Remove adapter III and install adapter II with plug. Connect LP gauge,
determine Δp by fully depressing the F and R accelerator pedals with the brake
released and engine running.
noyes
noyes
With the brake released, fully the depress F and R accelerator pedals and
determine the average wheel speed.
O
LM
Δp now 10 - 11 bar.
Δp now 10 - 11 bar.
Remote control servo
piston sticking or control
cylinder of cradle
defective.
Determine Δp by fully depressing the F and R accelerator pedals consecutively
with the brake released.
Leak in hydraulic remote
control. Repair fault or
renew remote control.
Install adapter III with LP gauge at ports ZF and YF of power limiter, fully
depress F and R pedals with brake released and engine running, and
determine Δp.
Leak in power limiter.
Remedy fault or renew
power limiter.
Travel control unit
malfunctioning. Check
setting and correct, if
necessary, with
reference to "Pressure
equality and start of
control", or renew the
unit.