Specifications

Page 2
Section 4.5
Service Training
4.5.1 ACCELERATOR AND BRAKE PEDAL ADJUSTMENT
ACCELERATOR PEDALS
- Bring both accelerator pedals to the same level, position bracket (1) on the leg spring (2) and secure them
with screws.
- With the aid of the spacer (WM 6), adjust the hexagonal screws (3) and (7) to a clearance of 48 mm from
the pedal and lock them with locknuts.
- Position the travel control 55 mm (WM 6) from the side of the pedal and secure it with screws.
- Clamp the adjusting lever (4) on the travel control shaft (shaft is in the neutral position when delivered).
BRAKE PEDAL
- Slide the stop (8) for the non-depressed pedal full up in the elongated holes.
- Slide the adjusting lever (5) onto the brake shaft of the control. Using a flat 10 mm spanner, turn the shaft
clockwise as far as the stop and clamp the adjusting lever in this position.
- Slide the stop (8) in the elongated holes fully down and screw tight in this position. This will relieve the
stress on the stop in the travel control.
- Using the spacer (WM 6), adjust the hexagonal screw (6) so that it is 48 mm from the pedal and lock it
in this position with the locknut.