Specifications

Page 10
Section 4.1
Service Training
09.06
4.1.1.6 CYLINDER HEAD
REMOVING THE CYLINDER HEAD
- With the engine cool, slacken the cylinder head bolts evenly and in steps in the reverse order as given
in the schematic "Cylinder head bolt tightening sequence".
DETERMINING THE CYLINDER HEAD GASKET
NOTE: For the adjustment of the gap, there are 3 different cylinder head gaskets, which identifiable
by holes.
- Place the dial gauge along with spacers 10075C on the sealing surface of the cylinder block and set the
dial gauge to "0".
- Turn the piston to TDC and note the projecting length of the piston at the points of measurement.
- Select the correct cylinder head gasket according to the largest projecting length of the piston.
Projecting length Identification of
of piston cylinder head gasket
0.43 - < 0.64 mm 1 hole
0.64 - < 0.74 mm 2 holes
0.74 - 0.85 mm 3 holes